Q: I took the scooter out of the box and it was dead on arrival.
A: We have a safety kill switch built into the X-360 brake handle. During shipment the safety switch sometimes becomes engaged. This is a simple one time fix. Simply loosen up the brake adjustment just a little on the handle bar by turning the brake adjuster on the brake handle in towards the brake handle. This will loosen the tension on the adjustment and safety switch and your scooter will start to work perfectly. You can test the safety switch by putting your scooter on a bench so the rear wheel is not contacting the ground to prevent an accident, then open the battery cover and find the wires marked Brake, unplug that connector from the other connector, then twist the throttle with the key turned on and the rear wheel will start to spin. This is a good way to eliminate the safety switch as being the problem. Make sure you plug the safety switch back in after doing this test to prevent future accidents while riding the scooter.
Q: My fuse is blowing out often.
A: Check the fuse to make sure it is a 30 AMP fuse that you have installed. Any thing less than 30 AMPS and the fuse may blow. The fuse is located under the battery cover in an orange or red fuse holder. Turn off the key to the scooter. Pull the fuse out of the rubber fuse holder. Look at the center of the fuse through the plastic, if the metal fuse inside is broken and burnt, simply replace the fuse with a 30 AMP fuse. This fuse is a standard automotive type fuse and you can get a replacement at any auto parts store or wal-mart store.
Q: My scooter has a flat tire.
A: We sell new tubes for each scooter we sell. Click Here to visit our parts page and order a new tube. Wal-Mart also carries the correct size tube for around $6. Make sure that when you remove the old tube that you carefully check inside the tire for the sharp object that popped your tube and remove it from the tire before you reinstall the new tube. Inflate your new tire to 40 LBS or more depending on the weight of the rider.
Click here for 2005
- 2006 X-360 step by step assembly instructions
Click here
for instructions to remove or replace the body of the scooter.
Click
here for instructions for the front fork assembly
Click here to
print A new owners manual in adobe PDF.
Click
here to view the rear wheel axle assembley of the scooter.
Click here to learn how to work on your X-360. This page will teach you how to troubleshoot any problems that you might experience. This page can also be helpful to owners of other brands that look very similar to the X-360. Please feel free to browse, print or take any information that you need for your scooter.
(Technical Support Hours Monday - Friday
9 AM - 5PM CST)
(Contact Technical Support ) Click Here
|
